1M/3M/5M/10M Victron Energy Orion XS 12/12 70A DC-DC Charger Kit

We've put this kit together to supply everything you need to wire up this 70A Victron Energy Orion XS DC-DC charger.

For use in dual battery systems in vehicles where the alternator and the starter battery are used to charge the leisure battery. The unit can be monitored and programmed via Bluetooth and can be remotely controlled via a remote on/off switch and has an engine running detection mechanism.

KIT CONTENTS

• Victron Energy Orion XS 12/12 70A DC-DC Battery Charger - ORI121221040
• 1M/3M/5M/10M 25mm² Wired Campers Pro Core Flex red battery cable
• 1M/3M 25mm² Wired Campers Pro Core Flex black battery cable
• Positive and negative leisure battery terminal set (8mm post)
• 2 X PVC battery terminal covers
• 2 X MEGA fuse holders
• 2 X 80 AMP MEGA fuses
• 20 X Self adhesive cable tie bases
• 20 X Cable ties
• All ring terminals, ferrules, and heat shrink to complete the installation

TECHNICAL INFORMATION

Engineered from the ground up, the Orion XS redefines adaptive DC-DC battery charging. For use in dual battery systems charged with a smart alternator. This device not only ensures top-tier performance but also guarantees the safety of your system.

The Orion XS serves as a DC-DC battery charger or as a power supply, offering a wide input and output voltage range. This is especially significant in the case of vehicles with a Euro 5 or Euro 6 smart alternator, which often supplies too low charging voltage even when the engine is running or when extended cable lengths, as is often the case in boats and RVs, lead to voltage drops.

In such scenarios, precise and controlled charging is imperative to fully charge the service battery while protecting the starter/input battery from discharge.

ADDITIONAL IMPORTANT INFORMATION

As with all the kits and layouts provided on our site, they serve as a guide only and we recommend all wiring and installation is carried out by a qualified professional. Disconnect all AC and DC power sources to prevent accidental shock. It is the installer’s responsibility to ensure compliance with all the applicable installation codes, regulations, and to ensure the equipment is fitted correctly.

Please note, this is in kit form so will require assembly (crimping/cutting cables).